hydraulic tracking molding machine for samples
HYCX-1 hydraulic tracking molding machine for samples mainly for molding of asphalt with mixtures when tracking test is carried out Technical parameters: 1.Specification of die setting:300×300×(30--100)mm 2.Radius of roller:500mm Width:300mm 3.Voltage:380V--3000W 4.Moving speed:6 times of backs/min 5.Pressure:0--20KN 6.Preheating temperature:Normal temperature---<200
Other supplier products
|
|
Основные технические параметры: |
SYD-2806E fully-automatic asphalt softening point device Asphalt Softening Point Tester Softening Point Apparatus Softening Point Tester The inst... |
|
|
three Gang Mould For Prisms |
three gang moulds three Gang Mould For Prisms Cement Steel 40mm Three Gang Cube Mould, for prisms 40 x 40 x 160mm is made of steel, base is made o... |
|
|
Mild Steel Cylinder Moulds |
Mild Steel Cylinder Moulds Cylinder Moulds We provide wide range of high quality concrete specimens mould such as cube, cylinder & beam with d... |
|
|
150mm Steel Cube Mould |
150mm Steel Cube Mould : 4-part with clamp attached base plate. Cube mould for concrete hardened testing. Machined surface finished by flat grindin... |
|
|
Rock free expansion rate tester |
Rock free expansion rate tester Rock Free Expansion Rate Testing ApparatusPurpose: rock free expansion rate tester practical rocks in the water is ... |
All supplier products
Same products
