10Pair Connection Module
10 Pair Telecom connection ModuleDescriptionsThis LSA IDC modules are used throughout the distribution level, in the main distribution frame (MDF), in the cross connection cabinet (CCC) and in the distribution point (DP) boxes. It is highly reliable and cost-effective wire connection system for modern telecommunications and data networks.It adopts IDC (Insulation Displacement Connection) technique, which means that no soldering, wire-stripping or the use of screws is necessary, and which clamps the wires at a 45 degree angle, thus dramatically reducing the risk of a poor termination and increasing the wiring productivity. The IDC contact is phosphor bronze, with silver plating.They use a normally closed two piece contact, with a convenient disconnection feature. By inserting a disconnect plug into a wire pair, you can temporarily or permanently disconnect the circuit. A test cord can be inserted into a pair to test each side of the circuit independently. This greatly accelerates fault identification.The center contact point can also be used for monitoring or overvoltage protection.Technical ParametersWorking temperature-40°C ~ 80°CRelative humidity≤93%(+40°C)Appearancethe color of all metal and plastic parts is uniform, without any scratch, rust, crusting and crackslabelsclear and completeConductor diameter range0.32mm-0.6mm, while insulation ≤ 1.4mmPulling strength≥25N while pulling from the vertical side of the contactsFlame retardant performanceall plastic parts are flame retardant, reaching grade of UL FV0Silver plating thickness0.5umLife circle≥200 timesMain Features1) Insulation Displacement Connection2) No Wire-stripping, screw and solder free3) Reliable connections4) Clear labeling5) Flame retardant performance6) Modular design and installations7) Gas tight connection8) Two wires per contact9) One push wire insertion10) No Wire-stripping, screw and solder free11) Only one inexpensive tool required
Other supplier products
All supplier products
Same products
