Shock Absorber Rod Guide
Shock absorber rod guide is made by powder pressing and sintering (Powder Metallurgy) technology.Some types will be inserted red PTFE DP4 sliding bushing in the inner diameter and do black steam oxidation depends on requirements. Technical information:1. Material: MPIF 35 FC - 0205Equivalent material: DIN 30910 - Sint C102. Chemical compositionDesignationFeCuCFC - 0205Balance1.5-3.9%0.3-0.6% 3. Hardness range: HRB 40 – 100 Before black oxidation (around 50 HRB) After black oxidation (around 85 HRB)4. Density range: 6.3-6.9 g/cm³ 5. Possible tolerance for ID: 0.03 mm, for OD: 0.05 mm6. General tolerance: ISO 2768 – m7. Degree of oxidation: 2-5%, thickness 0.003-0.005 mm Fe3O4 Packing of shock absorber rod guide: 1. Rolled by anti-rust kraft paper, 5 or 10 pcs per roller / Plastic blister packing2. Neutral standard carton or to your choice3. Wooden boxes or pallets Process flow of shock absorber rod guide:Powder mixing – Pressing – Sintering – Sizing – Ultrasonic cleaning – Steam oxidation – Oil impregnation – Final inspection – Packing – Storage Quality control of shock absorber rod guide:Work instruction paper and pictures at each working positionProcess flow card with each tray (Fully traceability)Sampling inspection and routing inspectionTS:16949 5 tools: PPAP, APQP, FMEA, SPC, MSADimensional report as per your requirement by CMM, projector, etc
Other supplier products
|
Oil Pump Stator |
Brief IntroductionOil pump stator is a basic component of oil pump, which co-work with the inner rotor or gear.We manufactured it by sintering (Po... |
|
Sintered Copper Bearing |
Sintered bearing, also named oil impregnated bearing, is made by powder metallurgy technology, which is pressed by the mould and do sintering, coin... |
|
Oil Pump Vane |
Brief introduction of oil pump vaneOil pump vane is made of bearing steel Gcr15(AISI 52100), we cut the steel sheet to little plates by laser. Then... |
|
Ring Gear |
When we intend to change the machining process to PM, we need to consider 4 questions: 1. The quantity is big enough to ensure the investment o... |
|
Shock Absorber Valve Body |
Shock absorber valve body is made by powder pressing and sintering (Powder Metallurgy) technology, then do black steam oxidation as per surface tre... |
All supplier products
Same products