813mm Marley cooling tower pvc fill with louver and drift eliminator

Marley Cooling Tower

M106 is a film-type, bottom-supported cooling tower fill. Water flowing down the fill sheets forms a thin film on the surface of the sheets. This type of fill provides much more water surface exposure per cubic foot than does splash-type fill.

M-106 fill is also available with highly efficient drift eliminators molded right into the fill sheets. Compared with older designs, these eliminators reduce water carryover (drift) from the tower by a factor of ten or more! Reduced drift means lower water and treatment chemical costs.

The nuisance of spotting adjacent buildings and property due to cooling tower drift is virtually eliminated. Options include eliminators for both vertical and horizontal discharge cooling towers. Guiding the discharge air in the right direction further increases savings in fan horsepower.

M-106 is easy and inexpensive to install in almost all crossflow cooling towers. It requires minimal structural modification because it is bottom supported. The integral drift eliminators don’t need extra frames or retainers. M-106 provides more cooling capacity and improved drift elimination in one easily installed pack.

Cooling Tower Fill

If you have any question, feel free to contact me,My :