China OEM High Silicon Cast/HSCI Iron Tubular/Stick Anode Manufacturers
Thanks for the progress of cast technology, tubular anode was invented after some years of stick anode. And now the tubular anode is very well recognized by CP designers and engineers and became the most popular for deep wells. The tubular anode has the following advantage against stick type.
Low resistance center connection is typically for tubular anode to compensate for end effect, because more current discharges from the anode end than the middle.
More economics because of higher utilization than traditional stick anode, tubular anode can use 85-90% of its mass weight while stick anode only 60-70%.
More surface area per kilogram which reduce the anode current density.
Tubular anode can be cast to 2134mm long while stick anode only limited to 1524mm, that brings the advantage of lower resistance than stick type.
Easy transportation and handling due to more surface area per unit weight, for a certain current requirement the weight of tubular anode is much smaller than stick anode.
Deyuan manufacture a full line of tubular anodes using improved centrifugal casting technique, this helps us to bring our anode quality to a new level compare to gravity casting.
More dense and homogeneous structure
Stipple effect increase surface area
Level 1 X-Ray detection AS per ASTM E186/E446
More impact resistance due to higher density
Other supplier products
|
Extruded Aluminium/Al Anode Manufacturers for Heat Plumbing/Water Srorage Tanks/Boilers |
1.Standard: ASTM 2.Application: Water Heater,Water container,Pre-polarization of steel structure in seawater,Gas pipe,Anti-corrosion of steel and i... |
|
Extruded Magnesium Anode Rod for Boiler Manufacturers |
Extruded Magnesium Anodes are usually used in a small diameter anodes requirement, such as for water heaters, boilers, water storage tanks, heat pl... |
|
China OEM Magnesium Alloy Welding Wire Manufacturers |
We produced welding wire following GB/T 5153 standard, with good welding performance.Grade and Specification of current products: AZ31B Φ1.2mm、... |
|
Sacrificial Zinc/Zn Ballast Tank Anode Manufacturers |
Sacrificial Zinc anodes are used in applications for protecting the pipelines and marine structures from corrosion in seawater and saline mud. Zinc... |
|
China OEM Petroleum Coke Backfill Manufacturers/Suppliers |
Petroleum Coke Back fill is designed for use in critical deep well or conventional ground bed. The back fill lowers anode-to-earth resistance, prov... |
All supplier products
Same products