Oil Pump Stator
Brief IntroductionOil pump stator is a basic component of oil pump, which co-work with the inner rotor or gear.We manufactured it by sintering (Powder metallurgy) technology.The advantages of PM stator are high efficiency, lower cost, more stable quality, because the sizes provide by mould.We do the finishing of two ends by korean lapping machine, the possible runout could be 0.03-0.05 mm. Density: 6.4-7.0 g/cm³Hardness: HRC 25-40 Material: DIN 30910 Sint C10 & D39DesignationFeCuCNiMoSint C10Balance1-5%＜0.3%Sint D39Balance1-3%0.3-0.9%1-5%＜0.6% Quality control system of oil pump stator:Work instruction paper and pictures at each working positionProcess flow card with each tray (Fully traceability)Sampling inspection and routing inspectionTS:16949 5 tools: PPAP, APQP, FMEA, SPC, MSADimensional report as per your requirement by CMM, projector, etc
Other supplier products
|
|
|
Sintered bearing, also named oil impregnated bearing, is made by powder metallurgy technology, which is pressed by the mould and do sintering, coin... |
|
|
|
Shock absorber signal wheel is made by powder pressing and sintering (Powder Metallurgy) technology, then do black steam oxidation as per surface t... |
|
|
|
Brief introduction of oil pump vaneOil pump vane is made of bearing steel Gcr15(AISI 52100), we cut the steel sheet to little plates by laser. Then... |
|
|
|
Shock absorber piston is made by powder pressing and sintering (Powder Metallurgy) technology.We will do the black steam oxidation and cover the ou... |
|
|
|
When we intend to change the machining process to PM, we need to consider 4 questions: 1. The quantity is big enough to ensure the investment o... |
供应产品
Same products
