Water Cooling Engraving And Milling Motorized Spindle

NameWater Cooling Engraving And Milling Motorized SpindleSerialnumberTechnical Parameter1 Cone Run-out(μm)1.27(max)2 Cylinder working pressure(kg f/cm2)3 Method of Tool ChangeManual4 Collet torque(N·cm)5 Static shaft deflection(μm)≤2.06 Dynamic shaft deflection(μm)≤8.07 Vibration(mm/s)≤1.08 Diameter of the assembly(mm)Φ61.902~61.919 Cooling water flow rate(L/min)water:≥1.6,oil:≥3.010 Cooling water pressure(kg f/cm2)water:≥2.5,oil:≥4.011 Motor winding insulation resistance(MΩ)≥500(H级)12 Motor winding voltage test(V/M)1500V/1minute motor winding voltage test13 Noise value(dBA)≤7214 Spindle dust blowing pressure(kg f/cm2)2.5~3.015 Spindle blowing dust gas flow(L/min)≥60  Website:http://www.eeja-xt.com


在线询价

至: Foshan Nanhai Xing Tuo Precise Machinery Co., Ltd
Your E-mail:
消息正文:


Send to other suppliers

Other supplier products

供应产品

Same products

卖方: ANKA Sci-Tech Co.,Limited PK
卖方: ANKA Sci-Tech Co.,Limited PK
卖方: ANKA Sci-Tech Co.,Limited PK
卖方: ANKA Sci-Tech Co.,Limited PK
卖方: ANKA Sci-Tech Co.,Limited PK