Refrigerated high speed centrifuge
How to use Refrigerated high speed centrifuge correctly?
To ensure safety and centrifugation, the instrument must be placed on a sturdy, level surface. No items should be placed on the engineering plastic door; the samples must be placed symmetrically and the nut must be tightened before starting. Before use, check the rotor for any flaws, corrosion, etc. At the same time, check the centrifugal cup for cracks, aging, etc. If you find any doubt, stop using it immediately and contact the factory, be sure to tighten the compression of the rotor before starting the machine. The nut is used to prevent the high-speed rotating rotor from flying out and causing an accident. The speed setting must not exceed the maximum speed to ensure the safe operation of the machine.
The centrifuge must be reliably grounded; if the machine is not in use, unplug the power cord. Check if the low speed centrifuge speed control knob is at zero position, the outer sleeve is intact and the rubber pad is padded.
The rotor is mostly made of aluminum alloy, flat and angled. The centrifuge tube has various types of hard glass, polyethylene hard plastic and stainless steel tube. The centrifuge is equipped with a drive motor, timer, regulator (speed indication) and refrigeration system (temperature adjustable range -20-40 °C), which can be replaced with different capacity and different types of speed depending on the centrifugal material. Email:
Other supplier products
|
|
High Speed Microcentrifuge |
High Speed Microcentrifuge is especially suitable for micro-filtration at high speed. The general speed is 16000r/min, and the capacity is relative... |
|
|
Low speed centrifuge |
1. If the glass tube breaks during the centrifugation process, the centrifuge cavity, the interior of the casing and the surrounding debris must be... |
|
|
High Speed Microcentrifuges are based on technology |
The High Speed Microcentrifugeis a high-tech product integrating multi-disciplinary and multi-technology. There are many manufacturers and products... |
|
|
Cyto Centrifuge |
Maintenance ofCyto Centrifuge
1. Before the centrifuge is operated, the power should be cut off and the centrifuge brake should be loosened first.... |
|
|
Low-speed centrifuge |
Low-speed centrifugeis a common model in the laboratory. The speed of the low speed centrifuge is lower than 10,000 rpm / min. The total volume of ... |
供应产品
Same products
