T50 accessories-good easy to pull
1.Made of steel wire rope
2.Density: 8(g/m)
3.Rod diameter 2(mm)
4.Temperature - 800 to 800 (℃)
5.Traction tension failure 800(kg)
Operation:
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
CPC-50A Hydraulic hand held tool |
Specifications Hydraulic cable cutter Head rotates 350 degree Flip top cutting head rotates 350 degree Two stage hydraulic to reduce cutting cycle ... |
|
cable drum jacks with stepped construction |
Use: support ladder type structure suitable for cable tray, you can use a variety of specifications of wire coil Trapezoidal wire laying frame, c... |
|
Electric grinder |
Powered Winches,Cable Winch,ENGINE WINCH,Cable Drum Winch,Cable pulling winch Application: It is used for tower erection, stringing in electric pow... |
|
THC-45 Safety Hydraulic hand Cu/Al cable Cutter |
FEATURES THC-45 Safety hydraulic wire rope cutter 1.Flip top cutting head rotates 350degree 2.Two stage hydraulic to reduce cutting cycle automatic... |
|
2016 hot sale Cable laying roller |
note: 1 Protect the conductor and pulling rope at wellhead bus-bar. 2 Leaning against the side of pithead directly while using. Used at the end of... |
供应产品
Same products