Clip Metal/Wire Mesh Grip/Cable Grips Cable Socks
Open weave hoisting grips provide an effective means for hoisting coax and elliptical waveguide into position and can be utilized to provide additional support once in place. The lace-up design allows the hoisting grip to be attached even when the run has been connectorized and facilitates easy positioning at 200 (61m) increments on long coax runs.
Other supplier products
|
|
Asia Cable pulling winch, CABLE LAYING MACHINES,Cable bollard winch |
engine winch/Cable Drum Winch Application: It's used for erecting pole, hoisting, stringing wire in power line operation. Powered winches are the c... |
|
|
L06S10 wall Tracing Duct Rod |
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secon... |
|
|
LOPG-1 OPGW cable grip pliers |
Wire clamping device is the power, telecommunications, railway electrification overhead line construction and maintenance of the commonly used to h... |
|
|
Fibreglass Duct Rodder Fish Tape on Frame & Reel for NBN Rodalong |
Features Constructed of fiberglass reinforced in the center and consists of a rugged plastic layer that would ensure the lifetime of the flexible r... |
|
|
BF-45 exportation fish tape |
Note: keep one hand holding the interior wall of Wire device while use it, and the other hand holding the handle of wire device, rotating clockwise... |
供应产品
Same products