L06S50 50M/6mm High strong Duct Rodders
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
BF-60 superior quality duct rodder |
Note: keep one hand holding the interior wall of Wire device while use it, and the other hand holding the handle of wire device, rotating clockwise... |
|
|
Quality Steel Material Cable Pulling Socks |
Cable Socks / cable pulling grip mainly used for all kinds of wire and cable (overhead conductors, insulated cables, etc.) of tractor pay-off const... |
|
|
Fiberglass Reel Wire |
Fiberglass duct rodder is an auxiliary tool applied in towing lead-rope through a pipe. The rod surface is hard and smooth, so it can get through t... |
|
|
BF-30 CBRL duct rodder |
Flexible reinforce fiberglass core with polyethylene coating. professional electricians rely on brand! It is Light, Strong and Smooth with a steel ... |
|
|
SKL Cable grip,Wire grip,Aluminum alloy wire grip |
Wire clamping device is the power, telecommunications, railway electrification overhead line construction and maintenance of the commonly used to h... |
供应产品
Same products
