L0730 eco duct rodder Vendor
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
T30 quick pulling / good leading tools |
1.Made of steel wire rope 2.Density: 8（g/m） 3.Rod diameter 2（mm） 4.Temperature - 800 to 800 (℃) 5.Traction tension failure 800（kg） Operation: 1.B... |
|
|
lifting tool, cable winch, cable grinder |
Powered Winches,Cable Winch,ENGINE WINCH,Cable Drum Winch,Cable pulling winch Application: It is used for tower erection, stringing in electric pow... |
|
|
L06S15 Cable Laying Tools |
1.Strong: maximum tensile damage coefficient under 700 kg (please don't exceed 700 kg, in order to avoid broken wire damage body), security departm... |
|
|
Cable roller SH450 |
note: 1 Protect the conductor and pulling rope at wellhead bus-bar. 2 Leaning against the side of pithead directly while using. Used at the end of... |
|
|
steel cable roller |
Detailed Description Used in the cable changing the direction place protection cable not to wear. Features Divides into according to the material q... |
供应产品
Same products
