T30 Feeney Cable Rail Lag Quick Connect 1/8"
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
|
SD-1000C Multi function wire grip |
Directions for manufacturer, whole saleand retail for all kinds of grips.TheCable Grip/clampsare widely used in power cable and communication line ... |
|
|
L0420 fiberglass push pull rod for NBN telcom fish tape |
Purpose: Cable puller is mainly used for in building installation wiring duct drawing guide line, as well as the protection communication cable, po... |
|
|
cash on delivery duct rodder |
Outer protect layer are made of high density polyethylene engineering plastic, which has good anti-UV capability. Cover was coated with long-term U... |
|
|
W0850T fish type obdurability |
then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold... |
|
|
T50 quick cable tight 50m with sleeve |
Operation: 1.Black spring and red glue to the above 2.Wire rope twists the figure 8 3.Wire wear into the figure 8, spring lock wire 4.Wire put into... |
供应产品
Same products