L0750 Hot Sales Product Competitive Price Duct Rodder
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
EZ-1550 Plug-in crimping plier |
parameter specification: Product model: EZ - 400 plug-in crimping pliers Output: 120 kn Scope: pressure was 16-400 Stroke: 38 mm Pressure welding n... |
|
|
NNEP fish tape |
The Reel Rod has a sturdy, powder coated, steel tube frame and features a 16" diameter storage basket. Up to 400 ft. of rod can be stored in this b... |
|
|
duct rodderwith strengthen the core |
A braided wrap of reinforcing fibers increases its rigidity and helps bond the core with the outer plastic coating. The coating is made from a poly... |
|
|
telecommunication for construction rodder |
The outside layer is smooth and firm ABS resin. It is widely used for the cables works or cleaning in cable pipe or channels. It has the advantages... |
|
|
cable puller,Cable Drum Winch,Cable pulling winch |
Mechanical drum trailer and hydraulic drum trailer Application: used for cable drum hauling and cable pulling-pushing. simple operation, stable and... |
供应产品
Same products
