T2 cable access kit push pull rod cable puller duct rodder
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
|
2016 hot sale Cable laying roller |
Used in the cable changing the direction place protection cable not to wear. Two vertical and one horizontal pulley made of precision steel Tube. ... |
|
|
DP011-10 cable jacks |
Trapezoidal wire laying frame, commonly known as "cable support" for placement of cable tray, overhead wires or cables, adopts a hydraulic device, ... |
|
|
AF-15 Direct Marketing duct rodder |
Note: keep one hand holding the interior wall of Wire device while use it, and the other hand holding the handle of wire device, rotating clockwise... |
|
|
L06S30 plastic steel cobra duct rod |
1.Fish type with 7cm wire head,, the end of with a quick pulling wire. 2.Wires for counterclockwise direction of rotation 3.Plastic steel cable pul... |
|
|
T2 cable access kit push pull rod cable puller duct rodder |
1.Black spring and red glue to the above 2.Wire rope twists the figure 8 3.Wire wear into the figure 8, spring lock wire 4.Wire put into red rubber... |
供应产品
Same products