FYG-300/400/500 Split type hydraulic crimping pliers
1 manual ratchet crimping pliers use and maintenance of the matters needing attention
2 don't charged line pressing, or in the vicinity of a charged conductor operations, can appear to avoid electrical shock.
3 crimping terminal crimping pliers pressure with the use of forceps must form a complete set. Terminal size and crimping pliers don't fit, there will be pressure to the phenomenon of insufficient or excessive pressure, and could lead to damaged crimping pliers and fault.
4 the crimping pliers handle not pressing ratchet mechanism doesn't work. Die on front end department shall be confirmed after the ratchet release.
5 crimping pliers for precision tools, shall not do him, not rough operation.
6 according to the frequency of daily use, crimping pliers, pin, shaft and bearing contact surfaces should be timely daub lubricating oil; Crimping pliers when not in use, its income tool box and storing clean, dry place.
7 when using the surface pressure molding department not to rust, damage and dirt. Crimping pliers, if in the case of die residual metal debris still use it, may result in incomplete or pressure to failure.
8 used for regular inspection tools, especially the ratchet machinery (pressure limiting device), etc., shall not continue to use in a loose situation.
Other supplier products
|
cable jacks with Hydraulic lifting |
DP014-5: Rated Load-5T, apply for drum dia 600-2400mm, application of disc width-below 1600mm, shaft diameter-76mm, weight-95kg DP014-5: Rated Lo... |
|
HZ-85 Hydraulic Cable cutter for cu/al cable |
FEATURE 1.Flip top cutting head rotates 350o 2.Two stage hydraulic to reduce cutting cycle, automatic release pressure when cut is completly stop ... |
|
cable puller,Cable Drum Winch |
The use of ground grinding security technology (1) the ground should be put on the flat, accessibility, and fixed tightly, prevent the ground plane... |
|
cable jacks distance between two rails adjustable |
Cable jacks according to usage is also referred to as the cable bracket, wire shaft disc rack, cable bracket. The form can be divided into, hydraul... |
|
T30 ELECTRICIANS PULLER RODS WIRES |
1.Made of steel wire rope 2.Density: 8(g/m) 3.Rod diameter 2(mm) 4.Temperature - 800 to 800 (℃) 5.Traction tension failure 800(kg) Operation: 1.B... |
供应产品
Same products