Coaxial Wire Stripping Machine
Operating procedures of semi-automaticcoaxial wire stripping machine.
1. Purpose
Establish proper equipment to prevent accidents and ensure the normal operation of equipment and improve work efficiency.
2. Precautions before work
2.1 The status symbol of each equipment shall be marked with the equipment name, equipment number, the initial opening time of the equipment and the department that uses the equipment.
2.2 Check whether the power is connected before work.
2.3 Check whether the working area is clean and in place. If the work site is to be cleaned, power must be turned off to avoid accidents.
2.4 Check whether the connection part of the machine is loose. If found, contact the equipment technician for inspection without delay.
2.5 Staff must be trained before the operation, and they can be hired after training.
3. Matters with attention during work.
3.1 When the machine is turned on, if there is any abnormal sound, please inform the equipment technician for inspection in time.
3.2 The staff shall not be allowed to move, disassemble equipment, test instruments, adjust the parameters set by the equipment. Contact the equipment technician if it is necessary.
3.3 The line should be placed in the middle of the clamps to avoid clamping the line.
3.4 If there is a new type of wire, it needs to be rotated. Firstly, the equipment technician shall adjust the equipment parameters and adjust the optimal state to be operated by the staff.
3.5 If abnormal conditions or abnormal detection results are found in the using process, the application shall be terminated immediately. The equipment technician shall be adjusted, and the calibration can be put into use after the repair.
3.6 Confirmation of deviation of inspection equipment shall be conducted to re-evaluate the products in the past and re-test if necessary.
Other supplier products
|
|
Kraft Tape Dispenser |
Kraft Tape Dispenser
BP-333 Gummed Paper Tape Dispenser
* Available Width: 38 ~ 76mm* Max. OD of tape roll: 178mm* Blades: Guillotine... |
|
|
Tape Cutting Machine |
Tape cutting machine is a kind of machine used to cut tape, protect film and flaky plastic material, which can be divided into automatic tape cutti... |
|
|
BJ-3000F Full-automatic Wire Strip & Terminal Crimp Machine |
Technical parameters ofBJ-3000F Full-automatic Wire Strip & Terminal Crimp Machine
Type
Automaticcomputersingleheadterminalcrimping... |
|
|
Wire Stripping & Cutting Machine |
Fully computer-controlled wire operation procedure
This procedure is about the fully computer-controlled wire stripping & cutting machine op... |
|
|
Tube Cutting Machine |
As the advancement of scientific technology, tube cutting machine bring forth the new through the old, with increasing varieties. According to the ... |
供应产品
Same products
