Advanced Specific Surface Area and Micropore Analyzer
Test Principle
Under low temperature conditions (e.g., liquid nitrogen bath, 77.3K), a certain amount of adsorbate gas (e.g., N₂) is introduced into the sample tube. The adsorption partial pressure is directly measured by controlling the equilibrium pressure in the sample tube, and the adsorption amount at this partial pressure point is obtained through the gas equation of state (PV=nRT). By gradually adding adsorbate gas to increase the adsorption equilibrium pressure, the adsorption isotherm is obtained. By gradually removing adsorbate gas to decrease the adsorption equilibrium pressure, the desorption isotherm is obtained. Compared with the dynamic method, no carrier gas (He) is required, and there is no need to repeatedly raise and lower the liquid nitrogen cup. Since the sample to be tested is in a fixed-volume sample tube, the adsorbate does not flow relative to the dynamic chromatographic method, hence the name static volumetric method.
Technical Parameters
◆Test functions: Evaluation of specific surface area, pore structure, and other gas adsorption properties
◆Types of adsorbates: Testing of various non-corrosive gases
◆Test range: Specific surface area above 0.0005 m²/g, pore diameter 0.35-500 nm
◆Number of analysis stations: 1/2 analysis station;
◆Number of degassing stations: 2 pretreatment stations;
◆Independence: The testing system and degassing system are independent of each other, allowing simultaneous sample testing and degassing;
◆Test accuracy: Specific surface area ≤±1.0%, most probable pore diameter repeatability deviation ≤0.15 nm, true density ≤±0.04%, external surface area ≤±1.5
◆Independent P0 station: Patented independent spiral saturated vapor pressure (P0) test station to ensure high accuracy of partial pressure testing
◆Temperature-programmed degassing: Software-controlled temperature programming, room temperature-400°C, accuracy better than 0.1°C; (customizable for special requirements)
◆Ultimate vacuum:
PS series: Original imported two-stage mechanical vacuum pump, vacuum degree 4*10-2 Pa,
PM series: 1 original imported turbomolecular pump + 2 original imported mechanical pumps, P/P0 as low as 10-8
◆Pressure measurement:
PS series: 1 original imported pressure sensor per test station, range 0-1000 torr
PM series: Multiple pressure sensors per test station, ranges 0-1 torr and 0-1000 Torr (0-0.1 Torr optional);
◆Open data interface: The software can be integrated with LIMS to upload test results to LIMS.
在线联系供应商
Other supplier products
 |
Ozone Test Chamber STD-AC22 | Feature Whole chamber inside and gripers made up of stainless steel, anti-corrosion. Outside of the chamber is baking finish (can choose SUS 304 ... |
 |
Big 45°Method Suture Flame Contact Times Tester | Product details This instrument is used for testing flame exposure times of flame retardant protective clothing stitches. Standards GB 8965-1998... |
 |
Metal ring friction and wear testing machine | Evaluate the wear resistance of the material: By simulating the friction process, real-time monitoring of friction, temperature, wear and other pa... |
 |
Spring torsion fatigue testing machine | Product Introduction: Spring torsional fatigue testing machine （horizontal） is a new type of automatic torsional fatigue testing machine with digi... |
 |
Fatigue Endurance Tester for Dental Implants | Standard ISO 14801:2016: Specifies dynamic fatigue testing protocols for endosseous dental implants, including load ratios, frequency, and failure... |
Same products
 |
Plasma Indicator Strips Tape | 卖方: Hopeway AMD | Plasma Indicator Strips Tape provides a convenient solution for monitoring plasma sterilization p... |
 |
Custom Stainless Components for OEM Applications | 卖方: Yongjia County Yaokang Technology Co., Ltd. | Our stainless steel float balls are designed for float valves, water tanks, and industrial liquid... |
 |
Precision Design for Automatic Liquid Level Control | 卖方: Yongjia County Yaokang Technology Co., Ltd. | Our stainless steel float balls are designed for liquid level control applications in valves, tan... |
 |
"China manufacturer power supply VM-5H3 for power generation | 卖方: DONGFANG YOYIK (DEYANG) ENGNIEERING CO; LTD | "China manufacturer power supply VM-5H3 for power generation Is to use the generator sets of prof... |
 |
Reliable Components for Water and Industrial Systems | 卖方: Yongjia County Yaokang Technology Co., Ltd. | The Stainless Steel Float Ball is designed for automatic liquid level control and fluid managem... |
