Fabric Fiber Shedding Degree Tester (Friction)
Instrument Testing Principle
Lay the specimen flat and fix it on the holder. Make the wet abrasive attached to the friction head perform reciprocating friction movements on the specimen under the specified load for a specified number of times with a certain stroke. Then compare it with the standard sample and visually rate the degree of fibers adhered to the abrasive to characterize the degree of fiber shedding of the specimen. It is suitable for factories, scientific research institutes, colleges and universities, import and export commodity inspection, textile testing in various provinces and cities.
Features
Touch screen controller: The number of frictions can be set arbitrarily.
Backup mechanical buttons for buttons in the touch screen: They can be used simultaneously, which is convenient and fast.
Pneumatic holder for specimen installation: Convenient and fast.
Equipped with a calender for adjusting the moisture content of the abrasive: The roll-off rate can be adjusted.
Complies with the standard: Appendix A of GB/T 40270 - 2021
Parameters
Stroke of the friction head: (200 ± 2) mm
Reciprocating speed: 30 times/min
Diameter of the circular friction head: (90 ± 1) mm
Outer diameter of the fixed clamp ring of the friction head: (120 ± 0.5) mm, inner diameter: (90 ± 0.5) mm
Diameter of the test washer: (113 ± 0.5) mm
Foam plastic washer: Diameter 105 mm, thickness 8 mm, unit area mass approximately 270 g/m²
Total mass of the friction load: (595 ± 7) g
Sandpaper: 600 - grit aluminum oxide water - washable sandpaper
Power supply: AC 220V, 50Hz
在线联系供应商
Other supplier products
 |
In-situ expansion analysis system | The In-situ Expansion Analysis System is designed for high-precision measurement of dimensional and volumetric changes in electrochemical cells and... |
 |
Gas Hazardous Characteristics Tester | Product Introduction This tester is used to test the flammable concentration range of gases in air. It is suitable for the vast majority of pure f... |
 |
Micro Controll Four-ball Friction Tester | The microcomputer-controlled four-ball friction testing machine uses a sliding friction method under point contact pressure conditions at the extre... |
 |
Rapid Crack Propagation meter | Standard ISO 13477: Designed exclusively for determining critical pressure (Pc) and temperature (Tc) in polyethylene pressure pipes during rapid... |
 |
Battery Electrode Resistance Tester | Standard ASTM B193: Standard Test Method for Resistivity of Electrical Conductor Materials ISO 18516: Conductive Coatings – Measurement o... |
Same products
 |
Plastic Smoke Density Tester F313 | 卖方: Standard International Group (HK) Limited | The F313 Plastic Smoke Density Tester is a precision instrument designed to measure the specific ... |
 |
Xenon Test Chamber | 卖方: Standard International Group (HK) Limited | Features and Benefits 1.The use of xenon arc lamp as a light source, can simulate the full sunli... |
 |
Single Cable Vertical Flame Tester | 卖方: 上海千实精密仪器 | Introduction Single Cable Vertical Flame Tester is used for the vertical flame propagation of a ... |
 |
Safety Helmet Flammability Tester | 卖方: 上海千实精密仪器 | Product Introduction: Safety hat flame retardant performance tester for safety hat flame retarda... |
 |
Furniture flammability tester | 卖方: 上海千实精密仪器 | Product details Furniture flammability tester is mainly used to test the combustion performance ... |
