MB Key NEC Programmer
This machine is use for new Benz Smart remote for Benz 220/215/210/202/203/219/211/231....
The new Mercedes device working with smart key (old and new) using in car since 1997 up to 2005 - without keylessgo system. You can program new key (ore used) in car and program oun key if its not work more.You read and program eeprom of CPU from Steering blocking module via diagnostic connector (38 pins). Desolder and read via programmer two CPU from Electronic Ignition Control Module.Load theese eeproms to program. Desolder NEC CPU from the key.Soldering it on the device , select the No of key and program it. Solder all CPU on their places and start the car.
You can program new keys without the car - only with EIS and steering blocking module.You can read theese CPU with help programmer (for ex. ETL) for Motorolla CPU 68HC705X16(32).
Other supplier products
|
|
Super VAG K+CAN |
As we know, there is very less diagnostic tool for VAG auto series, if we need to finish mixed, must need many diagnostic tool work together. Contr... |
|
|
X431 PC Center |
X-431 PCCENTER is an inclusive data management software kit integrating monitor, diagnosis, analysis, waveform display, update notice and remote se... |
|
|
Auto digi prog with super cables |
The AUTO DIGI PROG and all information in this manual are intended for repair of odometers only. When buying this product, the buyer promises to us... |
|
|
BMW GT1 |
BMW group tester one (GT1) is offered to the aftermarket in the same specification that is currently supplied to BMW franchised dealers. It is spec... |
|
|
T300 key programmer |
Used for programming of car keys. Models coverage: Acura, Audi, Alfa, Chevrolet, Citroen, Chrysler ( Dodge, Jeep), Daewoo, Ford Japan, Ford USA, F... |
供应产品
Same products
