T30 ELECTRICIANS PULLER RODS WIRES
1.Made of steel wire rope
2.Density: 8(g/m)
3.Rod diameter 2(mm)
4.Temperature - 800 to 800 (℃)
5.Traction tension failure 800(kg)
Operation:
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
|
CYO-400B separate hydraulic crimping pliers |
Hydraulic crimping pliers:Monolithic crimping pliers, crimping pliers need to separate with the corresponding pump, general suitable for electric o... |
|
|
TC-125S Hand cable cutter with telescopic handle |
Specifications: TC-125S cable cutter with telescopic handle,is forged, long life span and easy to cut. Feature: With telescopic handle. Attention:d... |
|
|
cable drum jacks with 5T 10T 15T |
DP014-5: Rated Load-5T, apply for drum dia 600-2400mm, application of disc width-below 1600mm, shaft diameter-76mm, weight-95kg DP014-5: Rated Loa... |
|
|
Portable ratchet scissors cable cutter |
Feature 1.Adjustable handles 2.Knives can be sharpened or replaced 3.It is convenient to use 4.The price is cheaper than other company 5.It can hel... |
|
|
Cable roller SH450 |
note: 1 Protect the conductor and pulling rope at wellhead bus-bar. 2 Leaning against the side of pithead directly while using. Used at the end of... |
All supplier products
Same products