L06S30 ECO Fishtape Puller
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
FISH SNAKE CABLE PULLER 11 MM X 250MTS |
Constructed of fiberglass reinforced in the center and consists of a rugged plastic layer that would ensure the lifetime of the flexible rod. Assem... |
|
|
Guide roller cable roller electric tools |
Electrical cable roller is a equipment for laying,pulling,guiding and protecting cable/rope/wire,which is a great way to save time and money. It is... |
|
|
Wire Cable L0410 Running Rod Duct Rodder Fishtape Puller 4.5mm |
Purpose: Cable puller is mainly used for in building installation wiring duct drawing guide line, as well as the protection communication cable, po... |
|
|
LBJ-25 Al-clad steel stranded wire grip,25KN wire rope clips |
Directions for manufacturer, whole saleand retail for all kinds of grips.TheCable Grip/clampsare widely used in power cable and communication line ... |
|
|
Straight line cable roller |
The cable roller can protect the cable, at the same time, cable block also can effectively reduce the friction of the cable, improve the constructi... |
All supplier products
Same products
