Cable grip connector for cable Cable Socks wire mesh grips
Cable Grips are a quick, efficient way to install/control electrical or heavy-duty cables. Cable Grips are re-usable (subject to inspection) and can also be used to support or pull any cylindrical object within their grip and load carrying capacity.
These Grip offer a flexible eye and double weave stainless steel wire construction for regual load pulls.Always read Breaking Strength,safety and technical data informatin. The approx mesh lengthis measured at an average grip diameter.
Open weave hoisting grips provide an effective means for hoisting coax and elliptical waveguide into position and can be utilized to provide additional support once in place. The lace-up design allows the hoisting grip to be attached even when the run has been connectorized and facilitates easy positioning at 200 (61m) increments on long coax runs.
Other supplier products
|
|
direct selling insulating rodder |
Features Constructed of fiberglass reinforced in the center and consists of a rugged plastic layer that would ensure the lifetime of the flexible r... |
|
|
Cable roller DPHC02 |
Electrical cable roller is a equipment for laying,pulling,guiding and protecting cable/rope/wire,which is a great way to save time and money. It is... |
|
|
Nylon Pulley |
The cable roller can protect the cable, at the same time, cable block also can effectively reduce the friction of the cable, improve the constructi... |
|
|
cable puller |
It mainly consists of two motor, one reduction box traction head and up frame, etc. It not only applied for traction power cable, communication cab... |
|
|
high quality of fish tape |
Fiberglass duct rodder features 1.Light weight,durable,resistance to acid,alkali,aging resistant,corrosion resistant. 2.High tensile strength and b... |
All supplier products
Same products
