Light-Medium Duty Cable Grips
These Grip offer a flexible eye and double weave stainless steel wire construction for regual load pulls.Always read Breaking Strength,safety and technical data informatin. The approx mesh lengthis measured at an average grip diameter.
Open weave hoisting grips provide an effective means for hoisting coax and elliptical waveguide into position and can be utilized to provide additional support once in place. The lace-up design allows the hoisting grip to be attached even when the run has been connectorized and facilitates easy positioning at 200 (61m) increments on long coax runs.
Other supplier products
|
|
Cable roller DPHC01 |
The cable roller can protect the cable, at the same time, cable block also can effectively reduce the friction of the cable, improve the constructi... |
|
|
Straight line |
The cable roller can protect the cable, at the same time, cable block also can effectively reduce the friction of the cable, improve the constructi... |
|
|
fish tape factory direct sales |
Features Constructed of fiberglass reinforced in the center and consists of a rugged plastic layer that would ensure the lifetime of the flexible r... |
|
|
with braking duct rodder/Fiberglass snake rod,Fish tape,Cable jockey |
Technical Date of Fiberglass Duct Rodder Specification Rod Diameter (mm) Φ 4.5-Φ 16 Rod Length (m) 30m~500m Frame Spec. (mm) 1300x450x1330,... |
|
|
Cable roller DPHC02 |
Electrical cable roller is a equipment for laying,pulling,guiding and protecting cable/rope/wire,which is a great way to save time and money. It is... |
All supplier products
Same products
