T2 wholesale quick pulling wire
Operation:
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
BS-30 eco duct rodderproducer |
Note: keep one hand holding the interior wall of Wire device while use it, and the other hand holding the handle of wire device, rotating clockwise... |
|
iberglass Cable Guide Roller |
Constructed of fiberglass reinforced in the center and consists of a rugged plastic layer that would ensure the lifetime of the flexible rod. Assem... |
|
BZ-240 electric crimping pliers adapt to 16-240 square |
parameter specification: Product model: EZ - 400 plug-in crimping pliers Output: 120 kn Scope: pressure was 16-400 Stroke: 38 mm Pressure welding n... |
|
factory Cable Guide manufacture Aluminium Roller |
1.Application: Used for guiding cable to turn and set free. and used for setting power cable and communication cable in trenchers or on ground. 2.... |
|
sewer movable rodder |
The Reel Rod has a sturdy, powder coated, steel tube frame and features a 16" diameter storage basket. Up to 400 ft. of rod can be stored in this b... |
All supplier products
Same products