T30 quick pulling with elasticity spring
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
|
traction tool, lifting tool, cable winch |
Powered winches are the construction tools of erecting electric circuits of high pressure electric transmission in the sky and laying eletrical cab... |
|
|
W0850T fish type obdurability |
then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold... |
|
|
cable wire device eco duct rodder |
High Density polyethylene (Grade: for the insulating and jacketing of Telecommunication Cables) is used in the outer diameter coating.Duct Rodders ... |
|
|
CYO-400B separate hydraulic crimping pliers |
when using the surface pressure molding department not to rust, damage and dirt. Crimping pliers, if in the case of die residual metal debris still... |
|
|
EP-510BH terminal crimping pliers |
when using the surface pressure molding department not to rust, damage and dirt. Crimping pliers, if in the case of die residual metal debris still... |
All supplier products
Same products