W0850T fish type obdurability
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
T2 CABLE RODDER REPAIR KIT |
Operation: 1.Black spring and red glue to the above 2.Wire rope twists the figure 8 3.Wire wear into the figure 8, spring lock wire 4.Wire put into... |
|
Powered Winches,Cable Winch,ENGINE WINCH |
Features Engine can start by switch. Easy operating. The brake can hold heavy materials when working stopped. Double frame can reduce the machine l... |
|
L06S10 street duct rodder |
1.Strong: maximum tensile damage coefficient under 700 kg (please don't exceed 700 kg, in order to avoid broken wire damage body), security departm... |
|
T30 quick pulling with 100ft storage box |
1.Black spring and red glue to the above 2.Wire rope twists the figure 8 3.Wire wear into the figure 8, spring lock wire 4.Wire put into red rubber... |
|
T30 Feeney Cable Rail Lag Quick Connect 1/8" |
1.Black spring and red glue to the above 2.Wire rope twists the figure 8 3.Wire wear into the figure 8, spring lock wire 4.Wire put into red rubber... |
All supplier products
Same products