L06S30 CBRL cable puller
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Other supplier products
|
|
BS-30 non-store seling movable rodder |
Fish Tape is designed for flexibility and easy navigation through conduit runs. The polypropylene case and handle are extremely durable and offer t... |
|
|
fish tape Direct Manufacturer |
Fiberglass duct rodder features 1.Light weight,durable,resistance to acid,alkali,aging resistant,corrosion resistant. 2.High tensile strength and b... |
|
|
HZ-65C/85C/105C Hydraulic Cu/Al cable Cutter |
HZ-65C/85C/105C armoured Cu/Alu cable cutter 1. Simple and convenient-opening C type cutting head 2.Double hydraulic stages alternately ensure the ... |
|
|
TC-250 Hand Cable Wire Cutter made of high tensive aluminum alloy |
TC-250 hand cable cutting tool with forging , long life span The handle is made of high tensive aluminum alloy, the knives are made by forging, lon... |
|
|
Economical 130mm Pressed Steel Pipe |
Electrical cable roller is a equipment for laying,pulling,guiding and protecting cable/rope/wire,which is a great way to save time and money. It is... |
All supplier products
Same products
