T30 ELECTRICIANS PULLER RODS WIRES
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Other supplier products
|
hydraulic lifting cable stand |
Application Hydraulic Cable Drum Jacks,/Cable Jack Stand is applicable to the placement of the cable tray, with hydraulic lifting. |
|
EZ-1550 Plug-in crimping plier |
parameter specification: Product model: EZ - 400 plug-in crimping pliers Output: 120 kn Scope: pressure was 16-400 Stroke: 38 mm Pressure welding n... |
|
CPC-40B cutter power cutting tools |
Specifications: CPC-40B Split- unit cable cutter head hydraulic cable cutter Flip top cutting head rotates 350°. Two stage hydraulic to reduce ... |
|
specially produce fish tape |
Outer protect layer are made of high density polyethylene engineering plastic, which has good anti-UV capability. Cover was coated with long-term U... |
|
BF-15 cash on delivery duct rodder |
Features: 1) Strong non-conductive fiberglass rod construction. 2) Rustproof bull-nose pulling eye. 3) For longer conduit runs and underground duct... |
All supplier products
Same products