Cable Hoisting Grip socks manufacturer similar as Greenlee
Open weave hoisting grips provide an effective means for hoisting coax and elliptical waveguide into position and can be utilized to provide additional support once in place. The lace-up design allows the hoisting grip to be attached even when the run has been connectorized and facilitates easy positioning at 200 (61m) increments on long coax runs.
Closed weave hoisting grips feature a closed-mesh design which simplifies installation over traditional split, lace-up style grips. The unique design allows the pre-laced hoisting grip to slip over an unterminated end of coax. The grip securely tightens when pulled, providing an effective means to hoist coax into position and to provide additional support for the coax once in place.
Other supplier products
|
CBRL insulating rodder |
Brand-New High Quality FibreGlass Duct Rodders or Snake Pullers can be used for NBN, Telecommunication, Electrician and other Department HDPE Pipe ... |
|
cable tractor winch, cable trailer winch |
engine winch/Cable Drum Winch Application: It's used for erecting pole, hoisting, stringing wire in power line operation. Powered winches are the c... |
|
Light weight rodder |
Constructed of fiberglass reinforced in the center and consists of a rugged plastic layer that would ensure the lifetime of the flexible rod. Assem... |
|
X-II German-style wire pliers,new type German-style wire grip |
Application: apply for steel strand、LJ、ASCR
Rated Load(KN)
Suitable Conductor
Safety Factor
Maximum Load
X-I
12
16-70
3
36
... |
|
Large cable jacks |
Application: Suitable for cable tray support. Hydraulic lifting, casters at the bottom, easy to move. For line construction, extending wire shelvi... |
All supplier products
Same products