pulling grip
Open weave hoisting grips provide an effective means for hoisting coax and elliptical waveguide into position and can be utilized to provide additional support once in place. The lace-up design allows the hoisting grip to be attached even when the run has been connectorized and facilitates easy positioning at 200 (61m) increments on long coax runs.
Closed weave hoisting grips feature a closed-mesh design which simplifies installation over traditional split, lace-up style grips. The unique design allows the pre-laced hoisting grip to slip over an unterminated end of coax. The grip securely tightens when pulled, providing an effective means to hoist coax into position and to provide additional support for the coax once in place.
Other supplier products
|
DNP fish tape |
There are meter marks on the protect layer of duct rodder, which can be used for measuring distance. Marks are printed by professional printing mac... |
|
fiberglass conduit rod reel |
High Density polyethylene (Grade: for the insulating and jacketing of Telecommunication Cables) is used in the outer diameter coating.Duct Rodders ... |
|
String cable roller |
Cable block is generally used in the ground and cable bridge frame protection of high voltage cable. The cable roller can protection 180 mm diamete... |
|
Three nylon sheave |
note: 1 Protect the conductor and pulling rope at wellhead bus-bar. 2 Leaning against the side of pithead directly while using. Used at the end of... |
|
Professional manufacture eco duct rodder |
High Density polyethylene (Grade: for the insulating and jacketing of Telecommunication Cables) is used in the outer diameter coating.Duct Rodders ... |
All supplier products
Same products