Cable roller SH450
note:
1 Protect the conductor and pulling rope at wellhead bus-bar.
2 Leaning against the side of pithead directly while using.
Used at the end of the manhole or pit entrance. Also,used to help lay cable on overhead cable trays.
Used in the cable changing the direction place protection cable not to wear,frames of corner rollers are linked together with stake pins to form a suitable bend to guide cables around the corner.
Other supplier products
|
perforation duct rodder |
Fiberglass duct rodder is an auxiliary tool applied in towing lead-rope through a pipe. The rod surface is hard and smooth, so it can get through t... |
|
middle cable pulling |
Cable Socks / cable pulling grip mainly used for all kinds of wire and cable (overhead conductors, insulated cables, etc.) of tractor pay-off const... |
|
movable cable jacks |
DP014-5: Rated Load-5T, apply for drum dia 600-2400mm, application of disc width-below 1600mm, shaft diameter-76mm, weight-95kg DP014-5: Rated Loa... |
|
SKG-50N anti-twist rope wire grip |
Application: apply for anti-twist rope
Rated Load(KN)
Wire rope Diameter(mm)
Weight(Kg)
SKG-50N
50
11-15
7
SKG-70N
70
16... |
|
distributor insulating rodder |
There are meter marks on the protect layer of duct rodder, which can be used for measuring distance. Marks are printed by professional printing mac... |
All supplier products
Same products