BC-300 electric portable crimping pliers
Operation process
1 Take the product from the packaging,at the same time, take out the required die in die card buckle.
2 Equipped with batteries and the terminal into the mould then press the switch to pressure; Pending after pressure to the piston will retract automatically, then loosen the switch can be reset, process is finished.
Other supplier products
|
engine winch,Cable Drum Winch,Powered Winch |
(1) the ground should be put on the flat, accessibility, and fixed tightly, prevent the ground plane to move or skewed. (2) run one end of the rope... |
|
Cable Hoisting Grip socks manufacturer similar as Greenlee |
mainly used for all kinds of wire and cable (overhead conductors, insulated cables, etc.) of tractor pay-off construction, is the electric power (o... |
|
Fiberglass Wire Cable Rod Fishtape Puller |
Available in lengths of 100m,200m and 300m with a wheeled cage for easy transport. The unit is available with meter markings and comes standard wit... |
|
Drum Roller Rails Cable Drum Rotators Coil unwinder / roller |
DP028-2: rated load 2T, thickness of bottom plate-6mm, dia of bottom plate-800mm, weight- 50kg DP028-3: rated load 3T, thickness of bottom plate-6... |
|
T30 quick pulling with 100ft storage box |
1.Black spring and red glue to the above 2.Wire rope twists the figure 8 3.Wire wear into the figure 8, spring lock wire 4.Wire put into red rubber... |
All supplier products
Same products