General Servo System Supports CANopen
General series servo system use the new digital signal processor (DSP) and intelligent power module (IPM);advanced optimization control algorithm improves the precise control of torque,Website:, speed and position; supports CANopen, standard Modbus communication protocol, output power range is 0.75 kW ~ 1.5 kW.Technical Parameter1.Power range: 0.4kW ~ 3.0kW2.Input voltage: single phase or three phase 220VAC (-15~+10%), 50~60HZ3.Control mode: position control, speed control, torque control4.Encoder type: 2500 linear incremental optical encoder (provincial line / non provincial line), 1024 wire rotary encoder5.Communication mode: RS485, RS232, CANopen, standard MODBUS communication protocol6.Input and output points: IO can be programmed to support the positive and negative logic settings, 8 input supports 16 kinds of functions can be carried out every function of the function of positioning, 4 output support for 10 kinds of functions which can be carried out in 1 ways7.Operation and display: 5 digital tube, 5 keys, or hand-held operation panel8.Monitoring function: to provide position, speed, current, voltage, input and output, and so on up to 30 kinds of state monitoringProduct Features1. Using a new digital signal processor (DSP) and intelligent power module (IPM), advanced control algorithm, to achieve high precision control of permanent magnet synchronous motor2. The combination of intelligent PID control algorithm and PDFF controller improves the rapidity and accuracy of position and speed control.3. The notch filter can be used to improve the following performance, reduce the noise and reduce the loss of the machine.4. The output signal of the encoder is supported at any frequency dividing ratio, which is more accurate.5. Support load disturbance observer, can carry forward torque and forward compensation, improve dynamic response of the system6 Inertia identification and automatic gain function simplify the debugging process of the system.7. Fan switch temperature can be set, according to the site needs to open air cooling, to provide environmental protection and more cost-effective application8. Support debugging software, mechanical characteristics analysis, parameter setting, monitoring and other functions, easy to operate9. The configuration of the hand held operator panel, parameter settings and system debugging is more convenient and quick
Other supplier products
All supplier products
Same products
