Medical Mask Differential Pressure Tester and breathability tester
Standards:
YY 0469-2011 Surgical mask
YY 0969-2013 Single-use medical face mask
EN 14683:2014 Medical face masks - Requirements and test methods
1, using the suction gas source as the instrument power source, free from test space constraint;
2, with a high precision differential pressure sensor, digital show the sample pressure of both sides;
3, special sample holder to ensure a good clamping sample.
Technical Parameters
Items Parameters
Air supply Suction type
Air flow 8L / min
Seal type O-ring seal
Sample breathable diameter Φ25mm
Differential pressure sensor range 0 ~ 500Pa
Display mode Digital display pressure difference
Power supply 220V, 50Hz
Other supplier products
|
mobile phone coating surface abrasion tester |
Alcohol Abrasion Tester is used to test the abrasion resistance of plastic surface handled by spraying or screen Printing, such as computer,mobile,... |
|
Universal Abrasion Resistance Tester |
Introduction·The instrument can be used to flat grinding, mill grinding, edge grinding, folding grinding and anti-frost, edge-close andfleec... |
|
Plastic Smoke Density Tester |
IntroductionThe main principle of smoke density measurement is that in a particular space, the cable or material produces smoke under specific comb... |
|
Curtain Flammability Tester |
IntroductionThis tester mainly based on NFPA 701 R & D and the United States NFPA 701 that provides fabric and film flame propagation test meth... |
|
IEC60695 Needle Flame Tester |
Standards:GB / T 4207-84, IEC 6112, ASTM D3638, DIN 53480 and UL 746A test methodsScope of application:Needle flame tester used not only for low-vo... |
All supplier products
Same products