Protective Clothing Liquid Static Pressure Tester
Instrument use:
The acid-proof clothing material anti-seepage acid static acid pressure tester is used to measure the acid-base anti-seepage of breathable acid-base protective clothing materials - static acid pressure resistance and liquid static pressure resistance.
Working principle:
The resistance to liquid static pressure borne by the fabric is used to indicate the resistance encountered by the test liquid through the fabric. Under the atmospheric pressure of 101.325kPa, the bottom of the sample is subjected to a continuously rising liquid pressure. Until there are three leaks, and the height of the liquid column at this time is recorded, which is called the fabric resistance to liquid static pressure.
Technical parameters:
1. Test solution: 80% concentrated sulfuric acid with different concentrations of acid and alkali
2. Rising rate of acid pressure test solution: (60±3) cm/min
3. Maximum pressure: 150mm liquid column "Maximum acid pressure: greater than 150mmH2SO4 (80%)"
4. Range: 0~150mm liquid column "0~150 mmH2SO4 (80%)"
Test preparation:
Take 3 samples from the finished protective clothing with a diameter of 32mm
Test steps:
1. The reagent contacts the sample vertically from below
2. Pressurize the reagent continuously and stably
3. Observe the sample and record the static pressure of the liquid when the third liquid drop appears on the sample
4. Each sample should be tested 3 times, and the arithmetic average is taken to obtain the static pressure value of the sample
Send product request
Other supplier products
 |
Mask BFE Testing Machine | Mask BFE Testing Machineis used to test the percentage of material containing bacterial suspended particles at a specific flow rate. Features: ... |
 |
Circular Locus Pilling Tester | The instrument is used to test the pilling conditions ofwool fabric, chemical fiber cotton, and blended, knitted, woven fabric to identify product ... |
 |
Particle Abrasion Tester | The Q-4D particle wear tester is specially designed as a standard instrument based on the national standard "Method for Determination of Wear Rate ... |
 |
Bone Screw Pull-out Tester | Standard YY/T 1506, ASTM F543: The standard specifies the torque required to measure the torque required to screw a metallic bone grafting screw ... |
 |
Safety shoe voltage tester | Product Information: The safety shoe voltage resistance tester is mainly used to test the voltage resistance of safety shoes under specified condi... |
Same products
 |
Air Permeability Tester STD- F8 | Seller: Standard International Group (HK) Limited | The Air Permeability Tester is designed to quickly and accurately measure the breathability and p... |
 |
Surface Performance Tester STD-FB4 - A | Seller: Standard International Group (HK) Limited | Introduction TheSurface Tester analyzes finger movements-particularly, strokes-performed by arti... |
 |
Compression Tester STD - FB3 - A | Seller: Standard International Group (HK) Limited | TheCompression Tester analyzes hand movements-particularly, pushing with a finger-performed by ar... |
 |
Single - Strand Bending Tester STD - FB2 - SH | Seller: Standard International Group (HK) Limited | Standards ASTM A370. ASTM A416. ISO6934.4 The Single Fiber Bending Tester makes it possible to ... |
 |
Bending Tester STD- FB2 - S | Seller: Standard International Group (HK) Limited | Compliance Standards ASTM D790 (Plastics Flexural Properties) ISO 178 (Flexural Strength of Rig... |
