Helmets Vertical SpacingInfrared - positioning Tester/ safety helmet vertical spacing tester / helmet fit measurement device
Purpose
This measuring instrument is used to measure the vertical spacing and wearing height of safety helmets.
Applicable Standard
GB/T 2812-2006
GB 2811-2019
Technical Parameters
1. Digital height gauge, which can display the height in real - time, with a measuring range of 0 - 500mm.
2. Adopts infrared positioning.
3. First, wear the test sample on the standard - specified head mold according to the standard requirements, and adjust it to make the heights on both sides of the hat hoop consistent.
4. Measure the vertical distance from the lowest point of the bottom edge of the hat hoop on the side of the sample to the top of the head mold as the wearing height, record the measured value and be accurate to 1mm.
5. Measure the vertical distance from the position of the point on the edge of the minor axis of the helmet shell relative to the head mold to the top of the helmet shell as X1.
6. Remove the wearing system and cushioning liners, place the sample on the head mold again, and ensure that the posture of the helmet shell is the same as before removal.
7. Measure the vertical distance between the same points as X2.
Send product request
Other supplier products
 |
G612 national standard shoe wear testing machine | Product Introduction: The whole shoe wear testing machine is used to test the wear resistance of soles and sole pieces. The principle is to press ... |
 |
Infusion Pump Flow Rate Tester | Infusion Pump Flow Rate Tester - Other test instrument - standard Product Information: Main Uses of the Infusion Set Flow Rate Tester The infusi... |
 |
textile spray rating tester ISO 4920 BS EN 24920 | Standards: ISO 4920. BS EN 24920. BS 3702. GB/T 4745. AATCC 22. M+S P23. NEXT 23 Applications: Fabric surface waterproof performance tester to d... |
 |
Diesel Water Ash Sulfur Mixing Tester | Meet the standard: ASTM D6304 ASTM D1744 ASTM D95 ASTM D482 ASTM D2622 ASTM D5453 ASTM D1266 Product Introduction: Analysis of water, ash, ... |
 |
Safety Helmet Impact Acceleration Tester | Purpose This instrument is suitable for impact - collision tests of helmets. It is a testing instrument used to evaluate the impact - resistance p... |
Same products
 |
Air Permeability Tester STD- F8 | Seller: Standard International Group (HK) Limited | The Air Permeability Tester is designed to quickly and accurately measure the breathability and p... |
 |
Surface Performance Tester STD-FB4 - A | Seller: Standard International Group (HK) Limited | Introduction TheSurface Tester analyzes finger movements-particularly, strokes-performed by arti... |
 |
Compression Tester STD - FB3 - A | Seller: Standard International Group (HK) Limited | TheCompression Tester analyzes hand movements-particularly, pushing with a finger-performed by ar... |
 |
Single - Strand Bending Tester STD - FB2 - SH | Seller: Standard International Group (HK) Limited | Standards ASTM A370. ASTM A416. ISO6934.4 The Single Fiber Bending Tester makes it possible to ... |
 |
Bending Tester STD- FB2 - S | Seller: Standard International Group (HK) Limited | Compliance Standards ASTM D790 (Plastics Flexural Properties) ISO 178 (Flexural Strength of Rig... |
