Carpet Peel & Tuft Test device
Product Details
For tufted carpets or traditional carpets, an important parameter is the retention performance of their tufts.
Poor - quality carpets may completely lose their tufts in certain situations, such as on staircases. For loop - pile carpets, well - formed loops can prevent the formation of long loops. This instrument can measure the force required to pull out a single tuft or loop from the carpet, that is, the bonding force between the carpet pile and the backing. This instrument is commonly used for testing small quantities of samples in laboratories, but it can also be applied in specific scenarios involving existing carpets or large - scale carpets.
Compliance Standards
BS 5229: 1975 (1996), ISO 4919: 1978
Test Method
The carpet sample is fixed by a steel template. Hold one end of the tuft to be tested with a pair of surgical forceps, or hook a loop with a metal hook. The surgical forceps or the metal hook is connected to a force - measuring balance, which is driven by a small electric motor to increase the pulling force at a steady rate. When the tension reaches its limit, the balance shows the required maximum tension. The maximum tension of the balance of the standard instrument is 5kg. When measuring carpets with greater tension, a balance with a capacity of 10kg can be selected. Dimensions: W430 mm, D300mm, H535 mm Power consumption: 20 W
Parameters
50 lbF, 25 kgF, 250 N
Peak memory for tensile loads
Accuracy: ± 0.3% of full scale ± digit
Safe overload: 150% accuracy
Selectable units of measurement: kg, N, or lbs
Push-button calibration
IPM – Intelligent Power Management system
Battery or AC operation
Send product request
Other supplier products
 |
Tensile and Shear Tester STD - FB1 - A | The Tensile and Shear Tester analyzes hand movements-referred to as "tensile"and "shear"-performed by artisans and professionals when judging a fab... |
 |
AATCC Gray Scale for Color Change | Standards AATCC Evaluation Procedure 1(Grey Scale for Stain and Color Change) ISO 105-A02(Grey Scale for Assessing Change in Color) JIS L 0801... |
 |
Goggles Puncture Resistance Testing Machine | Applicable standards: GB 811-2010 ECE R22.05 EN1077 Purpose It is to make a certain weight of sharp objects fall from the height specified i... |
 |
Photovoltaic module wire tube bending testing machine | The Photovoltaic Module Wire Tube Bending Testing Machine is designed to evaluate the mechanical durability and fatigue resistance of PV module out... |
 |
Coating abrasion resistance test device | Product Introduction: The determination of scratch resistance of the coating is very similar to the scratch test of the coating, but this test met... |
Same products
 |
Plastic Smoke Density Tester F313 | Seller: Standard International Group (HK) Limited | The F313 Plastic Smoke Density Tester is a precision instrument designed to measure the specific ... |
 |
Xenon Test Chamber | Seller: Standard International Group (HK) Limited | Features and Benefits 1.The use of xenon arc lamp as a light source, can simulate the full sunli... |
 |
Single Cable Vertical Flame Tester | Seller: Qinsun Instruments Co., LTD | Introduction Single Cable Vertical Flame Tester is used for the vertical flame propagation of a ... |
 |
Safety Helmet Flammability Tester | Seller: Qinsun Instruments Co., LTD | Product Introduction: Safety hat flame retardant performance tester for safety hat flame retarda... |
 |
Furniture flammability tester | Seller: Qinsun Instruments Co., LTD | Product details Furniture flammability tester is mainly used to test the combustion performance ... |
