Fire retardant wood burning test equipment

• 

Product Introduction:

Fire retardant wood stack method combustion test device is a test device developed and produced by referring to the People's Republic of China public safety industry standard GA/T42.1 "Fire retardant wood combustion performance test method - Wood stack method". MDF-1 type flame retardant wood wood stack combustion test device is suitable for testing the combustion quality loss rate and flame burning time of all kinds of wood with thickness above 20mm in production and engineering after flame retardant impregnation treatment under specified combustion conditions.

Working conditions:

1. Ambient temperature: room temperature —— 35oC

2. Ambient humidity: ≤70%

3. working voltage: AC 220±10V

4. gas source: natural gas, liquefied petroleum gas

5. timing accuracy: 3min±GA/T 42.1 Flame retardant wood burning performance test method wood stack method 0.1s

6. temperature error: 310oC≤±10oC

Specimen preparation:

1. The specimen size is 76mm×13mm×13mm, the cutting error is ±1mm, and the surface is required to be smooth and flat. Three sets of 24 pieces were prepared for each test piece.

2. The specimen is cut 0.6mm away from the longitudinal end of the wood, less than 1m long wood, and cut from the middle to both sides.

3. the specimen cut from the upper and lower sides of the width of the wood along the thickness direction parallel cut 13mm×13mm test piece two layers, and then cut 76mm along the length direction of the test piece, the remaining center part is not sampled.

4. before the test, the specimen must be at a temperature of 23±2oC, relative humidity (50±5) % of the condition, so that its quality is constant. The determination condition is the interval of 24h, the mass change of two weighing before and after each group is not more than 1%.

Other supplier products

	Bag Plastic Buckle Durability Tester	Product Introduction: It is mainly used to test the service life of plastic plug-ins in luggage accessories. Technical standard: QBT 5247-2018 ...
	Single wire and cable vertical combustion tester	Main use G233 Fabric vertical combustion tester is mainly used to evaluate the combustion characteristics of plastics and other non-metallic mater...
	Shoelace Abrasion Tester	Application: This shoelace abrasion tester is used for shoelace against standard eyelet abrasion testing, or eyelet against standard shoelace abra...
	Direcct flame impingement Tester with BS 476-12	Introduction: The testeris designedaccording to the BS476-12:1991.Method of test for ignitability of products by direct flame impingement.The accu...
	Helmet Webbing Micro - displacement Abrasion Tester	Main Purposes It is used to detect the abrasion condition of the webbing, the micro - displacement performance of the webbing, and the fatigue lif...

Same products

	Plastic Smoke Density Tester F313	Seller: Standard International Group (HK) Limited	The F313 Plastic Smoke Density Tester is a precision instrument designed to measure the specific ...
	Xenon Test Chamber	Seller: Standard International Group (HK) Limited	Features and Benefits 1.The use of xenon arc lamp as a light source, can simulate the full sunli...
	Single Cable Vertical Flame Tester	Seller: Qinsun Instruments Co., LTD	Introduction Single Cable Vertical Flame Tester is used for the vertical flame propagation of a ...
	Safety Helmet Flammability Tester	Seller: Qinsun Instruments Co., LTD	Product Introduction: Safety hat flame retardant performance tester for safety hat flame retarda...
	Furniture flammability tester	Seller: Qinsun Instruments Co., LTD	Product details Furniture flammability tester is mainly used to test the combustion performance ...