Charger Products- Third Party Inspection 100% Quality Control
This check is conducted during the very early stages of the production process (between 0 and 20%). The purpose of the check is to inspect the process parameters and to verify that the final product will meet the desired quality requirements.
We are humans and naturally humans make mistakes, so do factories in China. About half of the factories in China have production issues. If no strict quality check is performed, factories will make according to their standard. That is why to determine the faults earlier is a time and cost saving process,when you figure out the problems when all goods are finished, it will waste lots of time and money to revise. In our experience, we did a quality control while the production just had started, we figured out the color the factory used was totally different from what the customer wanted. This is a major fault. After check up, the factory revised the color immediately. If we performed a quality check after the products are almost finished, this could be a major issue and the shipment will be delayed due to the revision of the issues found at the quality control.
So it is strongly recommended to do a quality check in the early stage of the production process. This quality control is required in China especially to avoid misunderstanding and faults in the further production process.
Отправить запрос, связаться с поставщиком
Другие товары поставщика
 |
Hourglass inspection service quality QC on-site inspection | $150USD All inclusiveanywhere in China for 1 Manday Inspection. 2. Service Introduction : Whether you are developing products, projects, or proce... |
 |
Intelligent Balanced Vehicle- Third Party Inspection 100% Quality Control | Final Random Inspection can begin only after production is completed and all merchandise is ready and packed for shipment. We will verify product s... |
 |
Inspection service China for gingers | The pre-shipment Inspection takes place when the merchandise is 100% completed, and at least 80% of the products are packed, marked. Our inspectors... |
 |
Plastic cup inspection services and quality control of Guangdong Huajian Inspection Co., Ltd | Inspection Service * Marsky Solutions, an inspection company in China, founded in 2009. * Help buyers audit suppliers. do quality inspections, supe... |
 |
Sewing machine Products- Third Party Inspection 100% Quality Control | During Factory Evaluation we will examine your suppliers capabilities, systems, management, and operating procedures. We will inform them of (or re... |
