polymeric isocyanate (MT-44V20)

• 

General Properties and Applications

MT44V20 is a liquid, dark brown polymeric isocyanate based on diphenylmethane-4,4′-diisocyanate (MDI) with isomers and homologues of higher

functionality. It is used in conjunction with polyols to produce polyurethane.

Sampling

Exposure to moisture must be prevented when taking product samples

Storage

Recommended storage temperature: + 10 to + 30 °C (in exceptional cases up to 50°C)

Storage stability (ex works): 6 months if stored in moisture-tight drums Labeling and REACH applications This product data sheet is only valid in conjunction with the latest edition of the corresponding Safety Data Sheet. Any updating of safety-relevant information – in accordance with statutory requirements – will only be reflected in the Safety

Data Sheet, copies of which will be revised and distributed. Information relating to the current classification and labeling, applications and processing methods and further data relevant to safety can be found in the currently valid Safety Data Sheet.

Directions for Processing

MT44V20 may undergo partial crystallization at temperatures below 0 °C. The product can, however, be brought back into the liquid state by heating the entire contents of the drum for a short time to a maximum of 70 °C, although this may lead to an increase in the solids content.

Drums including empty ones should always be kept tightly sealed. The product should never be allowed to come into contact with water, which reacts with MT44V20 to form polyureas and carbon dioxide.Contact with water in any form (damp drums, solvents containing water, moist air) must be prevented not only during storage, but also when removing material from drums and during processing.Failure to do so may lead to a dangerous build up of pressure in tanks and drums due to the generation of carbon dioxide. In addition, polyureas forming in MT44V20can cause solids to separate out, leading to blockages in the filters, pumps and pipelines of the processing equipment and resulting in production problems.

Другие товары поставщика

	Thermal interface material	Thermal conductive sealant There are two types of thermal conductive joint fillers: silicon-based and non silicon. They are usually two-component ...
	CAS 127-63-9  Diphenyl sulfone s-127	Introduction CAS:127-63-9, 127-63-9 – Names and Identifiers Name Phenyl sulfone Synonyms s-97s-127DifenylsulfonphenylsulPheny...
	Leveling agent STD-2041	Composition: Polyether modified silicone oil Appearance: light yellow viscous liquid Active ingredient: 100% Solvent: None Application range: ...
	Indanthrone Blue CAS 81-77-6	Introduction TestItem Specification Contofwater%≤ 2.5 Soluble matter in water %≤ 2.0 Oil a...
	Non Modified Cellulose Ether	Introduction Non Modified Cellulose Ether To improve the workability properties of Portland cement and gypsum based dry mortars, such as plaster,...

Похожие товары

	Epoxy/Polyester Powder Coatings	Продавец: Standard International Group (HK) Limited	Feature: -Good bond ability and mechanical performance -Smooth and glossy -Certified chemical ...
	Polyester Clear Powder Coatings	Продавец: Standard International Group (HK) Limited	This series of product are made of polyester resin (as hardener) and highly transparentmaterials....
	Acrylic Clear Powder Coatings	Продавец: Standard International Group (HK) Limited	Feature: -Excellent exterior exposure durability -Excellent durable high gloss -Excellent clar...
	Polyurethane Powder Coatings	Продавец: Standard International Group (HK) Limited	Feature： -Excellent exterior exposure durability -Good flowing -Excellent chemical resistance ...
	MDF Powder Coating	Продавец: Standard International Group (HK) Limited	Feature： -Environmental friendly -No solvents and volatile organic compounds involved which are...