T50 Electricians Puller Rods Wires Draw Push Pulling
1.Made of steel wire rope
2.Density: 8(g/m)
3.Rod diameter 2(mm)
4.Temperature - 800 to 800 (℃)
5.Traction tension failure 800(kg)
Operation:
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Другие товары поставщика
|
|
BZ-85 hydraulic battery power Cable Cutter |
Cutting force:60KN Stroke: 86mm Cutting cycle:70 times Cutting range:dia 85mm (Cu/Al cable and armoured cable) Voltage: 18v Capacity: 3.0Ah Chargin... |
|
|
superior quality insulating rodder |
Features Constructed of fiberglass reinforced in the center and consists of a rugged plastic layer that would ensure the lifetime of the flexible r... |
|
|
BS-30 rodder with cable kit |
Note: keep one hand holding the interior wall of Wire device while use it, and the other hand holding the handle of wire device, rotating clockwise... |
|
|
Mechanical release frame |
applicable to be as the support of large cable reel in laying cables in the city easy to move with the trundles in the bottom can be equipped with ... |
|
|
cash on delivery Glass fiber reinforced plastic cleaning rod |
Fiberglass duct rodder is an auxiliary tool applied in towing lead-rope through a pipe. The rod surface is hard and smooth, so it can get through t... |
Все товары поставщика
Похожие товары