W0830 Good Rigidity Duct Rodder
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Другие товары поставщика
|
|
Cable Running Rod L0410 |
This product adopts import international advanced technology formula spring steel plastic materials, high strength, high elasticity, high toughness... |
|
|
TC-38 Hand handle types of Tool |
Features: 1.Strong,light weight glass fiber handle. 2.Adjustable pivot bolt realized adjustable blade. 3.Changeable,forging blade heat treated and ... |
|
|
EZ-85 battery powered armoured Cable Cutter |
1.All tools can be controlled by one key-press the trigger to start working, half loosing the trigger means stopforcing pressure, loosing fully mea... |
|
|
T50 Electricians Puller Rods Wires Draw Push Pulling |
1.Made of steel wire rope 2.Density: 8（g/m） 3.Rod diameter 2（mm） 4.Temperature - 800 to 800 (℃) 5.Traction tension failure 800（kg） Operation: 1.B... |
|
|
YQK-240 a new type of crimping pliers |
1 manual ratchet crimping pliers use and maintenance of the matters needing attention 2 don't charged line pressing, or in the vicinity of a charge... |
Все товары поставщика
Похожие товары
