W0850T electric cable puller
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Другие товары поставщика
|
|
T2 cable access kit push pull rod cable puller duct rodder |
Operation: 1.Black spring and red glue to the above 2.Wire rope twists the figure 8 3.Wire wear into the figure 8, spring lock wire 4.Wire put into... |
|
|
BS-15 DNP eco duct rodder |
Hand-held wire threading device is one kind of exporting products of our company, product features: reasonable design, safe and durable. appearance... |
|
|
cable winch on sale |
The use of ground grinding security technology (1) the ground should be put on the flat, accessibility, and fixed tightly, prevent the ground plane... |
|
|
cable winch, Maneuvering release line |
It mainly consists of two motor, one reduction box traction head and up frame, etc. It not only applied for traction power cable, communication cab... |
|
|
cable bundling trestle Cable rollers linear cable pulley |
Electrical cable roller is a equipment for laying,pulling,guiding and protecting cable/rope/wire,which is a great way to save time and money. It is... |
Все товары поставщика
Похожие товары
