T30 ELECTRICIANS PULLER RODS WIRES
Operation:
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Другие товары поставщика
|
L0420 4.5mm X 20 Metre Fiberglass Rodder |
1. The model steel and wire one-piece fusion, more wear-resisting, safe load of 300 kg。 2. Spring steel wire head, can rotate 360 degrees, can be b... |
|
Triple Corner Roller |
Electrical cable roller is a equipment for laying,pulling,guiding and protecting cable/rope/wire,which is a great way to save time and money. It is... |
|
Coated Fiberglass Continuous Duct Rodder with Cage and Stand |
Purpose: Cable puller is mainly used for in building installation wiring duct drawing guide line, as well as the protection communication cable, po... |
|
AF-15 FRP Drainage duct rodder |
The unique sloped handle optimizes the position of your hand for quick hand-over-hand rewinds and allows a more level payout of tape on the backswi... |
|
CYO-510B 50-400 square crimping pliers |
1 manual ratchet crimping pliers use and maintenance of the matters needing attention 2 don't charged line pressing, or in the vicinity of a charge... |
Все товары поставщика
Похожие товары