L06S20 sewer pipe inspection tools
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Другие товары поставщика
|
wholesale eco duct rodder |
Constructed of fiberglass reinforced in the center and consists of a rugged plastic layer that would ensure the lifetime of the flexible rod. Assem... |
|
BS-30 FOB cable duct rod |
Features: 1) Strong non-conductive fiberglass rod construction. 2) Rustproof bull-nose pulling eye. 3) For longer conduit runs and underground duct... |
|
Tray Rollers Ground-cable laying |
Electrical cable roller is a equipment for laying,pulling,guiding and protecting cable/rope/wire,which is a great way to save time and money. It is... |
|
Aluminium cable roller |
Nylon wheel are pouring, larger load and bearing all adopt the Harbin bearing, reduce the friction between the cable pulley and cables Type: Tubula... |
|
cable stand with Horizontal release frame |
DP028-2: rated load 2T, thickness of bottom plate-6mm, dia of bottom plate-800mm, weight- 50kg DP028-3: rated load 3T, thickness of bottom plate-6... |
Все товары поставщика
Похожие товары