W0850T electric cable puller
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Другие товары поставщика
|
|
DP011-5 cable drum jacks |
DP011-3: Rated Load-3T, apply for drum dia 700-2100mm, application of disc width-below 1500mm, shaft diameter-60mm, weight-75kg DP011-5: Rated Loa... |
|
|
HZ-85 Safety Hydraulic Cable Cutter |
1. Flip top cutting head rotates 350o 2.Two stage hydraulic to reduce cutting cycle, automatic release pressure when cut is completly stop 3. Manua... |
|
|
CPC-100B split cable cutting head |
Split hydraulic cable cutter can work with hydraulic hand pump or electric hydraulic pump, it is suit for big size of tele cables or armoured Cu/Al... |
|
|
TC-100 mechanical cable cutter |
1.Strong, light weight glass fiber handle 2.Adjustable pivot bolt realized adjustable blade 3.Changeable,forging blade heat treated and precise pol... |
|
|
Underground Cable Roller |
Detailed Description Used in the cable changing the direction place protection cable not to wear. Features Divides into according to the material q... |
Все товары поставщика
Похожие товары
