L0750T CBRL duct rodder
Method of use: First, reasonable arrangement good direction of the wire line pipe, elbow is best use of pipe bender bending, fixed line pipe. Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader. Note: when you pull hard, need to tap the line pipe.
Другие товары поставщика
|
|
T50 accessories-good easy to pull |
Operation: 1.Black spring and red glue to the above 2.Wire rope twists the figure 8 3.Wire wear into the figure 8, spring lock wire 4.Wire put into... |
|
|
Vente directe eco duct rodder |
Feed device allows rod to feed out or be back with easy push or pull of rod Rugged tubular steel reel with adjustable positioning Rustproof bull-no... |
|
|
THC-85 powerful hydraulic wire cable cutting tool |
Specifications hydraulic cable cutter Cutting range:DIA.45mm Cu/Alu cable and Amoured Cu/Alu cable Flip top cutting head rotates 350°. Two stag... |
|
|
belt drive or shaft drive, cable winch |
The use of ground grinding security technology (1) the ground should be put on the flat, accessibility, and fixed tightly, prevent the ground plan... |
|
|
CBRL duct rodder |
High Density polyethylene (Grade: for the insulating and jacketing of Telecommunication Cables) is used in the outer diameter coating.Duct Rodders ... |
Все товары поставщика
Похожие товары
