L06S30 Customized push pull rodder
Secondly, the threader either side across the line pipe, tube at the other end pull out a short online, then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold and firm, with several lines need to enter the same line pipe, and ground them in together, wrapped with tape from the line pipe slowly in the past, the most, on the other end pull the threader.
Другие товары поставщика
|
|
Fish Tape Fiberglass Wire Cable Running Rod L0415 |
The plastic steel cable puller’s diameter of 4.5mm, pull strength is more powerful than before, with lighter weight and good quality, it is t... |
|
|
cable wire device |
Fiberglass duct rodder is an auxiliary tool applied in towing lead-rope through a pipe. The rod surface is hard and smooth, so it can get through t... |
|
|
Indoor type insulating rodder |
Available in lengths of 100m,200m and 300m with a wheeled cage for easy transport. The unit is available with meter markings and comes standard wit... |
|
|
Horizontal release frame type cable jacks |
Used to support wire reel when laying cable .Hold up the wire tray. Usage: for expanding the wire, the whole set of line on the six equal parts of ... |
|
|
BS-30 new type eco duct rod |
The unique sloped handle optimizes the position of your hand for quick hand-over-hand rewinds and allows a more level payout of tape on the backswi... |
Все товары поставщика
Похожие товары
