T2 cable puller accessories
1.Black spring and red glue to the above
2.Wire rope twists the figure 8
3.Wire wear into the figure 8, spring lock wire
4.Wire put into red rubber
5.Wire rope wear into the cable puller bullet hole, make a knot.
Другие товары поставщика
|
fish tape in bulk |
High Density polyethylene (Grade: for the insulating and jacketing of Telecommunication Cables) is used in the outer diameter coating.Duct Rodders ... |
|
X-II German-style wire pliers,new type German-style wire grip |
Wire clamping device is the power, telecommunications, railway electrification overhead line construction and maintenance of the commonly used to h... |
|
BZ-45 Battery hydraulic cutter for Cu/Al cable armoured cable |
Li-ion batteriesdo neither have a memory effect nor self-discharge. Even after long periods of non operation the tool is always ready to operate. I... |
|
Vente directe duct rodder |
The Reel Rod has a sturdy, powder coated, steel tube frame and features a 16" diameter storage basket. Up to 400 ft. of rod can be stored in this b... |
|
L06S50 Tracing Duct Rod |
then, will need to enter the line pipe lines each thread cut to about 5 cm, take a piece of bare wire into the threader head small hole circle fold... |
Все товары поставщика
Похожие товары